Data Acquisition Mode Settings - Teltonika FMB1YX User Manual

5.8

Data Acquisition Mode settings

Data Acquisition Modes are an essential part of FMB1YX device, it is also highly
configurable.
By configuration user defines how records will be saved and sent. There are three different
modes: Home, Roaming and Unknown. All these modes with configured data acquisition and
send frequencies depend on current GSM Operator defined in Operator list (see chapter GSM
Operators, Roaming and Blacklist Operator list) and are switched when GSM operator changes
(e.g. vehicle passes through country boarder).
If current GSM operator is defined as Home Operator, device will work in Home Data
Acquisition mode, if current operator is defined as Roaming Operator, device will work in
Roaming Data Acquisition mode, and if current operator code is not written in Roaming Operator
list, device will work in Unknown Acquisition mode.
This functionality allows having different AVL records acquire and send parameters values
when object is moving or stands still. Vehicle moving or stop state is defined by Stop Detection
Source parameter. There are 4 ways for FMB1YX to switch between Vehicle on Stop and Vehicle
Moving modes, see section 5.4 , Table 12. Object Motion Detection Settings.
FMB1YX has 6 different modes. Operational logic is shown in Figure 19.
If home operator will be written to roaming operator list any part, it will be
detected as home operator, not roaming.
Figure 19 Data Acquisition Mode operational logic
46