Teltonika FMB900 How-To

https://wiki.teltonika-gps.com/view/How_to_connect_OBD_II_Bluetooth_Dongle_to_FMB_device
How to connect OBD II Bluetooth Dongle to
FMB device
Main Page > Frequently Asked Questions - FAQ
Contents

1 How to connect OBD II Bluetooth Dongle to FMB device

1.1 Solution applies for these FM devices

1.2 Bluetooth settings configuration

1.3 Connecting to Bluetooth OBD II dongle
1.4 Supported Bluetooth OBD II dongles
How to connect OBD II Bluetooth Dongle to FMB device
Solution applies for these FM devices
FMB900 FMB920 FMB110 FMB120 FMB122 FMB125 FMB202 FMB204 FMB962 FMB964 FMT100
FMM125 FMM130 FMU125 FMU130 FMC125 FMC130 FMB910 FMC920 FMM920 FMB130
FMB140 FMB230 FMB225 FMC230 FMM230
Bluetooth settings configuration
The following are the instructions on how to easily prepare a Bluetooth Dongle connection to the
FMB device. First, we need to configure FMB device Bluetooth settings. These are the required
steps:
Go to Bluetooth
Turn on BT Radio by pressing
automatically be "FMB1YX_last 7 imei digits", you can leave it or type your own name.
Set Security Mode (position 4) to
list only security mode but in this case you need to type external device MAC address in
Authorized Devices MAC List (position 7).
Set connection mode to
Set External Name as your Bluetooth OBD II device name for proper device identification and
connection to it. In this example the OBDII device name is "DONGLE", at least 2 characters
are needed to recognize it and connect to it. For better and faster adapter identification in the
network, you could enter a full device name. You could check your OBDII adapter Bluetooth
name by scanning nearby Bluetooth devices using a mobile phone or a computer with a
Bluetooth adapter.
Go to OBD II
figure.
section similarly to as shown in the figure to the right (position 1).
Enable (visible)
OBDII (position 5).
in main menu and select priority and others parameters visible in the following
> How to connect OBD II Bluetooth Dongle to FMB device
(position 2). "Local name" (position 3) will
PIN only or None (you could select PIN + MAC list or MAC