Security Info; System Settings - Teltonika FMB1YX User Manual

 GSM status: modem status, SIM status, GPRS status, actual operator code and GSM signal
level.
 GPRS traffic: how much data has been send from device and received from device.
 Sockets information: what server domain and port is used.
 Records: how much records were sended to server from last data reset, when last record
send to server was and when was last server response.
 SMS count: how much FMB1YX received SMS and how much SMS was send from device.
In OBD info user can see main information from OBD (if device connected to vehicle with
OBD II Bluetooth dongle adapter): vehicle VIN code and used OBD protocol.
In CAN Adapter info user can see main information from LV-CAN200/ ALL-CAN300 (if device
connected to LV-CAN200/ ALL-CAN300): program number and LV-CAN200/ ALL-CAN300 SW
version
In I/O info user can see all I/O element values from all configurable I/O elements.
5.3

Security info

In security section user can see SIM card and configurator keyword security information.
 User can see SIM1 and SIM2 state and now connected to device SIM card current
status. If used SIM card with PIN code user can enter it here. How much attempts
left to enter pin code is showed to.
 When SIM PIN code is entered correctly user can change PIN code or disable it from
SIM card. When SIM PIN is disabled and user what to enable it again user must
enter last used PIN code.
 If into device are inserted two SIM cards, user can change PIN code to both of them.
 For configuration security keyword can be set to configurator. Keyword can be
saved in configuration file (.cfg), so there is no need to connect the device to the
configurator to configure keyword. Min keyword length is 4 symbols and max
length is 10 symbols. Only uppercase and lowercase letters and numbers are
supported. Keyword can be configured to .cfg configuration file when device is not
connected to device.
5.4

System settings

System settings have 9 configurable parameters:
 Sleep settings, where user can choose sleep mode;
 Ignition source, where user can choose between power voltage, digital input 1,
accelerometer and engine RPM as ignition sources. More than one ignition source
can be selected at the same moment. User can select movement start and
movement stop delay time (in seconds): those parameters are used when ignition
source is accelerometer. Into ignition status take the following functionalities:
power manager, eco driving, excessive idling, fuel consumption, over speeding,
towing and trip functionalities.
 Object Motion Detection Settings, where user can configure 4 ways how FMB1YX
will detect stopped movement, and change its working mode (for working modes,
read section 5.8). Other functionalities that depend from movement source: power
manager, fuel consumption and trip.
37