Teltonika FMB1YX User Manual page 38

 Static navigation settings, where user can turn static navigation on or off.
Additional, user can chose from what source (movement or ignition) static
navigation can be deactivated/activated;
 Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
 GNSS source Settings, where user can choose satellite system.
 LED indication, where user can turn on or off indication leds.
 Battery charge mode, where user can choose when battery will be charged: on
need (battery will be charged anytime when it need to be charged) and after
ignition ON (battery will be charged only when ignition is on).
 Analog Input value range, where user can choose analog input range 10 V or 30 V
(10 V range for now works same as 30 V range).
 Time synchronization settings, where user can choose from what source (or
sources) FMB1YX time will be synchronized. User has choice to use only one
synchronization source by GNSS. When selected synchronization from NTP, time
will be synchronized from NTP server and from GNSS. When selected
synchronization from NITZ, time will be synchronized from GSM operator and GNSS.
When selected synchronization from NITZ+NTP, time will be synchronized from all
three sources (if it is necessary). Every time GNSS fix will be acquired time will be
synchronizes (if needed). User can select from what NTP server (possible to
configure two servers) time will be synchronized and what time period (in hours) is
used to resynchronize time.
Table 12. Object Motion Detection Settings
Movement Source
Ignition
(recommended)
Movement
(movement sensor)
Movement Source
GPS
CAN speed
Static Navigation Mode is a filter, which filters out track jumps when the object is
stationary. If Static navigation filter is disabled, it will apply no changes on GPS data. If Static
navigation filter is enabled, it will filter changes in GPS position if no movement (configured
movement source) or ignition (configured ignition source) is detected (depends on what static
navigation settings is selected: movement, ignition or both sources). It allows filtering GPS jumps
when object is parked (is not moving) and GPS position is still traced.
Vehicle on Stop mode
If ignition (ignition source) is logic
low
Internal movement sensor does
not detect movement
Vehicle on Stop mode
GPS fix is available and vehicle
speed is lower than 5 km/h
While GPS fix is unavailable, Object Motion Detection Settings are
working like in Msensor mode
If speed from BT OBDII dongle is
equal 0 km/h
Vehicle Moving mode
If ignition (ignition source) is logic
high
Internal movement sensor detects
movement
Vehicle Moving mode
GPS fix is available and vehicle
speed is higher than 5 km/h
If speed from BT OBDII dongle is
higher that 0 km/h
38