Excessive Idling; Unplug Detection; Towing Detection - Teltonika FMB1YX User Manual

5.10.1 Excessive Idling

When vehicle stops for specific amount of time
scenario is activated, record will be generated and
digital output status will be changed to 1 (if
configured). You can configure time it takes to turn
on this scenario (Time to Stopped). Scenario is
activated until vehicle starts moving and keeps
moving (moving is detected only from accelerometer)
for amount of time that is configured. You can
configure time it takes to turn OFF this scenario (Time
to Stopped).

5.10.2 Unplug Detection

Unplug Detection. Eventual event will be generated
when FMB1YX
from external power or plugged back again. User can
select detection type: simple – used in cars, where power
voltage is not dependant on ignition (recommended);
advanced – used in cars, where power voltage is
disconnected when ignition is switched off.

5.10.3 Towing Detection

FMB1YX activates towing function when these conditions are met:
1. Ignition (configured Ignition Source) is OFF.
2. Activation Timeout (set in Towing detection features) is reached.
When Activation Timeout is reached and Ignition is still in OFF state, FMB1YX monitors
accelerometer data. If Acceleration or Angle value reaches configured threshold for configured
Duration (in ms), check Ignition state. If Ignition is still OFF during configured "Ignition check after
1
FMB125 don't have DOUT 2 selection
is unplugged
Figure 29 Exccessive Idling configuration
parameters for FMB120 and FMB122
Figure 30 Unplug detection configuration
1
54