Teltonika FMB1YX User Manual page 88

7.3 SIMPLE-CAN - contactless CAN-BUS reader
SIMPLE-CAN is contactless adapter used to read
vehicle CAN data with LV-CAN200, ALL-CAN300. If LV-
CAN200 or ALL-CAN300 connection requires two CAN lines
to get all data, then you need two SIMPLE-CAN readers
TECHNICAL DETAILS
 Power supply voltage 9-63 V
 Power supply current:
Mode
Active
Standby
 CAN-BUS speeds from 33,33 to 500 kb/s
 Automatically sets CAN Low, CAN High polarity
 Automatically adjusts signal level and speed
SIMPLE-CAN works in the listening mode only, so not all the data available on the CAN-BUS
may be received using this solution. The device automatically sets CAN L/H polarity, but the
calibration has to be always executed during installation process. Connection of previously
calibrated unit to another car needs new calibration because the reader automatically adjusts
signal level and speed to different CAN-BUSes. The device also automatically adapts to the
found noise level.
After power supply connecting, LED shines continuously. It means that device waits
for calibration. Calibration process has to be carried out when CAN-BUS twisted pair is tightened
on SIMPLE-CAN and when the ignition is ON. Please press the switch shortly and wait for the LED
12V 24V
8.3 mA 4.3 mA
1.6 mA 0.91 mA
Figure 81 Teltonika SIMPLE-CAN pinout
Figure 80 Teltonika SIMPLE-CAN
88