Dout Control Depending On Functionality Priority; Autogeofencing Settings - Teltonika FMB1YX User Manual

period continues until scenario turns off. DOUT ON and DOUT OFF duration parameters must be
configured in ms.

5.12 DOUT control depending on functionality priority

All DOUT control functionalities now have their own priority (non-configurable). Depending
on priority DOUT control may be overtaken by higher priority functionality without finishing
previous scenario.
DOUT control scenarios and functionalities by priority:
 Immobilizer (highest priority)
 DOUT control via call
 iButton Notification
 Green Driving
 Jamming
 Overspeeding
 Idling
 DOUT control via SMS (lowest priority)
For example, if jamming will be detected during Overspeeding, then Jamming functionality
will control DOUT.

5.13 AutoGeofencing settings

AutoGeofence – the last known position after movement = off. If your car's being
taken away – you can be notified. The shape and size of the geofence zones are
parameters. It is possibility to state whether entering in or out of the geofence triggers an
asynchronous message.
AutoGeofencing option can be configured by following parameters visible in figure 34
below.
Activation Timeout (s) – when ignition is turned off and activation timeout passes, as
AutoGeofence will be created around vehicle last position with set radius value.
Radius (m) – radius of circle with center device coordinates after activating AutoGeofence
feature.
Deactivate By:
Digital Input 1 – If DIN1 voltage becomes equal or higher than 6,9 V it will disable
AutoGeofenze Zone.
Digital Input 2
AutoGeofenze Zone.
Digital Input 3
AutoGeofenze Zone.
iButton – if authorized iButton is attached.
Power Voltage – if power voltage become higher that low voltage level (Ignition
settings) it will disable AutoGeofenze Zone.
Engine RPM – If engine RPM became higher that 0 it will disable AutoGeofence
Zone.
Feature – Priority of generated event, which will be applied to saved record.
1
FMB125 don't have Digital Input 2 selection
2
FMB125 don't have Digital Input 3 selection
1
– If DIN2 voltage becomes equal or higher than 2,1 V it will disable
2
– If DIN3 voltage becomes equal or higher than 3,5 V it will disable
57