Teltonika FMB1YX User Manual page 105

9 PARAMETER LIST
9.1 System parameters
9.1.1 Sleep Mode (ID=102)
Device has three sleep modes: GPS sleep, Deep Sleep and Online Deep Sleep mode. While
sleep is disabled (value 0) module will never enter sleep mode, in sleep mode (value 1) module
reduces level of power usage by turning GPS module to sleep, in deep sleep mode (value 2)
module turns GPS module to sleep and device is deregistered from network (note, that FMB1YX
do not receive SMS while in deep sleep), online Deep Sleep mode (value 3) device works as in
Deep Sleep mode, but without deregistering from GSM network. GSM part stays powered, so
this increases power consumption. In this mode, device should received/send SMS and
make/receive calls. Also not closes GPRS context, if previously opened.
Minimum Maximum
value value
0 3
9.1.2 Sleep timeout (ID=103)
Sleep timeout is time after which FMB1YX goes to GPS sleep, Deep Sleep or Online Deep
Sleep if other requirements are met. It is measured in minutes.
Minimum Maximum
value value
1 3000
9.1.3 Movement Source (ID=100)
Device can operate and change its working mode according to motion detection source:
ignition (value 0), movement sensor (value 1), GPS (value 2), CAN speed (value 3).
Minimum Maximum
value value
0 3
9.1.4 Static Navigation (ID=106)
When static navigation is enabled, FMB1YX filters out GPS jumps, when it is not moving.
When it is disabled, it does not make any changes to collected GPS data.
Minimum Maximum
value value
0 1
Default value Goes with (depends on)
2 Sleep timeout (ID=103)
Default value Goes with (depends on)
10
Default value Goes with (depends on)
1
Default value Goes with (depends on)
Static Navigation Settings
1
parameters
parameters
Sleep Mode (ID=102)
parameters
-
parameters
(ID=112)
Value
type
Uint8
Value
type
Uint8
Value
type
Uint8
Value
type
Uint8
105