Overspeeding Scenario; Jamming Detection; Trip; Dout Control Via Call - Teltonika FMB1YX User Manual

PLEASE NOTE that Eco Driving functionality generally is dependent on
accelerometer. Auto calibration must be done before using ECO driving
scenario. All information about auto calibration descrybed in 5.9.1.2 chapter.
4.4.2

OverSpeeding Scenario.

Helps to prevent from exceeding fixed speed and inspects driver if needed. Digital output
can be controlled by scenario for user needs, to manage buzzer, LED, etc.
4.4.3

Jamming detection

Jamming detection shows when GSM signal jamming occurs. Digital output can be
controlled by scenario for user needs, to manage buzzer, LED, etc.
4.4.4

Trip

Trip customizable feature enables user extended monitoring of performed trips (from
engine start at present location to engine stop at arrived location), log their start and stop points,
view driven total distance
Odometer calculation source can be selected between GNSS, OBD or LVCAN.
Note: Scenarios and Trip feature are activated (DOUTs are activated) only if
ignition is on.
4.4.5

DOUT Control Via Call

Activates DOUT on incoming call
Note: in Excessive Idling, Jamming and Trip scenarios if Eventual Records is
enabled Event will be generated (included into send records) only when
scenario starts and finishes. If Eventual Records is disabled scenario status
value is sent in each AVL record.
4.4.6

Immobilizer

Immobilizer Scenario. Vehicle can be used only if iButton is connected. If iButton List Check
is enabled gives ability to use vehicle only for 500 specific iButton owners (specified in iButton
list). If iButton List Check is disabled connect any iButton to pass Immobilizer security. Digital
output can be controlled by scenario for user needs, to manage buzzer, LED, etc.
1
Continuous trip odometer – total driven distance, works only in TRIP mode. Continues distance is
counted only for ONE trip. If trip is finnished (stop point is detected), odometer resets to 0 (zero). Next trip will start
counting from the begining. Betwen Records trip odometer – another odometer that are used only in TRIP mode. In
this mode distance will be counted until any record is made, then odometer will be reseted to zero and started
counting to next record again.
1
and calculate eco score value.
32