Connecting To Bluetooth Obd Ii Dongle - Teltonika FMB920 User Manual

4. When device configuration is loaded press „Bluetooth" settings (Figure 37 1 position).
5. Turn on BT Radio by pressing „Enable (visible)" (Figure 37 2 position). "Local name"
(Figure 34 3 position) automatically will be "FMBxx_last 7 imei digits", you can leave it or
type your own name.
6. Set Security Mode (Figure 37 4 position) to "PIN only" or "None" (you could select "PIN +
MAC list" or "MAC list only" security mode but in this case you need to type external
device MAC address in "Authorized Devices MAC List" (Figure 37 7 position).
7. Set connection mode to "OBDII" (Figure 37 5 position).
8. Set „External Name" as your Bluetooth OBD II device name for proper device
identification and connection to it. In this example OBD II device name is „DONGLE" but
at least 2 characters are needed to recognize it and connect to it. For better and faster
adapter identification in network you could enter a full device name. You could check
your OBD II adapter Bluetooth name by scanning nearby Bluetooth devices using mobile
phone or computer with Bluetooth adapter.
9. Go to "OBD II (Bluetooth)" in left menu and select priority and others parameters visible
at Figure 38.
10. After all these steps press „Save to device" to save configuration (Figure 37 8 position).
11. Now you can disconnect FMB device from a configurator.

5.19.2 Connecting to Bluetooth OBD II dongle

After this configuration you could connect your car OBD II dongle to FMB device. Turn on
ignition then turn on its Bluetooth connection. For pairing follow your dongle instructions
II device notification about paired Bluetooth connection depends on specific model. If you later
restart FMB device it will automatically connect to this dongle.
6
OBD II dongle Bluetooth connection pairing instructions depends on specific model.
Figure 38 OBD II Bluetooth settings.
6
. OBD
59