Bluetooth; General Functionality - Teltonika TMT250 User Manual

Hide thumbs Also See for TMT250:

Table of Contents

Eventual records controls where scenario status value appears: when disabled it will exist

in each AVL record and when enabled the value will be appended only to eventual records.

OverSpeeding helps to configure OverSpeeding scenarios separately for each different

Geozone. Regular OverSpeeding and geozones' OverSpeeding function independently. If digital

output control is enabled in a regular OverSpeeding scenario, geozones OverSpeeding scenario

will control it too i.e when the device is in more than one geozone and OverSpeeding is detected

in any zone then the digital output turns on. Digital output turns off only when OverSpeeding is

not detected anywhere.

X1 is used to set geofence zone left bottom corner X coordinate (longitude) whereas Y1 is

used to set Y coordinate (latitude).

X2 or R are used to set accordingly geofence zone upper right corner X coordinate

(longitude) when Rectangular zone is used or circle radius when Circular zone is used. Y2 sets

geofence zone upper right corner Y coordinate (latitude) for a Rectangular zone.

5.12 Bluetooth

General functionality configures Bluetooth to work in slave mode. This mode allows any

external device to connect to TMT250.

Figure 22 Geofence configuration

Table of Contents