Trip Continuous Distance Counting (Id=1283); Geofencing; Frame Border (Id=1020); Geofence Zone #1 Shape (Id=1030) - Teltonika FM1200 User Manual

8.6.10 Trip Continuous distance counting (ID=1283)

For this feature I/O#11 ODOMETER must be enabled. If I/O ODOMETER is
enabled, and Continuous distance counting variable is set to Continuous (value 1), TRIP
distance is going to be counted continuously (from TRIP start to TRIP stop) and shown
as I/O ODOMETER value.
Minimu Maximu
m value m value
0 1

8.6.11 Geofencing

In this chapter it is explained how to get all parameters for the first Geofence zone
(all ID numbers are for the 1st zone). And at the end of the chapter (part 8.6.10) is
presented a table with the IDs of all the rest Geofence zones.
8.6.11.1

Frame border (ID=1020)

Geofence border thickness, measured in meters.
Minimu Maximum
m value value
0 1000000
8.6.11.2

Geofence Zone #1 Shape (ID=1030)

Geofence shape parameter can be: circle – value 0; rectangle – value 1.
Minimu Maximu
m value m value
0 1
8.6.11.3

Geofence Zone #1 Priority (ID=1031)

Parameter defines Geofence priority: 0 is low, 1 – high, 2 – panic;
Minimu Maximu
m value m value
0 2
8.6.11.4

Geofence Zone #1 Generate Event (ID=1032)

Generate event on:
a) No event – value 0
b) On entering zone – value 1;
c) On exiting zone – value 2;
d) On both – value 3;
Minimu Maximu
m value m value
0 3
Recommende Goes with (depends on)
d value
-
I/O#11 – Odometer (ID = 1410-
Recommende Goes with (depends on)
d value
1000 All Geofencing parameters
Recommende Goes with (depends on)
d value
-
All Geofencing parameters
Recommende Goes with (depends on)
d value
-
All Geofencing parameters
Recommende Goes with (depends on)
d value
-
All Geofencing parameters
parameters
Trip (ID=1280)
1415)
parameters
parameters
parameters
parameters
Value
type
U8
Value
type
U32
Value
type
U8
Value
type
U8
Value
type
U8
64