MIMAKI TS100-1600 Operation Manual page 39

4
Wipe off any ink on the ink bottle caps with paper wipes.
• Check to confirm that there is no foreign matter, such as paper towel scraps or dust,
adhering to the ink bottle caps. Continuing to use it when it is dirty may result in foreign
matter blocking the ink channels, causing ink leakage.
5
Remove the ink bottle caps from the ink bottles.
• If the ink bottle caps are tight, remove using a tightening tool.
6
Remove the ink IC chip.
• When disposing of the product, contact an industrial waste disposal operator or dispose of
the product in accordance with the local laws and regulations.
l Preparing the Ink bottle
1
Shake the Ink bottle to the left and right slowly at least 20 times.
• Tighten the ink bottle lid securely, then shake the bottle slowly from left to right to ensure that the
ink moves inside, holding the ink bottle lid with a paper towel.
• Shake slowly. If the bottle is shaken too violently, ink may leak out or the air mixed in the
ink may cause nozzle clogging.
• If the ink bottle is partially used, tilt it slowly until the ink bottle is upright.
2
Remove the ink bottle lid.
Repeat the procedure.
39
Chapter 1 Before Use
1