Printing; Changing The Origin; Starting Printing - MIMAKI TS100-1600 Operation Manual

2.9 Printing

• Was the print head adjusted?
• Is media loaded?
• For roll media, is the rear roll media free of sagging?
• When using the take-up unit, was the media mounted on the paper core of the take-up unit?
"Loading the Roll Media"(P. 56)

Changing the Origin

The print start position can be altered. Use the LED pointer to set the origin.
• Print origin default value
– Feed (longitudinal, X') direction: Approx. 75 mm to rear from platen cutting slot
– Scan (lateral, Y') direction: 15 mm from right edge of media
1
On the LOCAL mode screen, press
• The Origin Setup screen appears.
2
Press
• The carriage moves left and right and feeds the medium.
3
Press the [ENTER] key.
• The origin is updated.

Starting Printing

1
Send the RIP data from the PC.
• "Preparing RIP data"(P. 67)
• When the message "Attention20A Driver version" appears, install the latest Mimaki driver
available from:
Check beforehand
"Adjust Print Head Height"(P. 51)
"Loading the media"(P. 53)
Cutting
slot
to move the origin to the desired position.
https://mimaki.com/download/inkjet.html
15 mm (Y')
Approx. 75 mm (X')
.
69
Chapter 2 Printing
2