MIMAKI TS100-1600 Operation Manual page 40

Chapter 1 Before Use
• If the mouth of the ink bottle is fitted with a seal
(1) Cut the seal open using a craft knife. There is a risk of ink leakage if parts of the seal
remain.
(2) Take care not to damage the mouth of the ink bottle. There is a risk of ink leakage if
the mouth is damaged.
(3) Be careful not to drop any of the seal fragments into the ink bottle. If the ink bottle is
used with seal fragments inside, these may clog the bottle cap, preventing ink from
being supplied.
3
Attach the ink bottle caps to the ink bottle.
• If the seal fitted to the mouth of the ink bottle is lifting up, press it back down as shown in
the figure below before attaching the bottle cap. Attaching the bottle cap with the seal left
lifted up may result in ink leakage.
• Wipe off any ink or maintenance liquid remaining on the ink bottle or bottle cap. Otherwise
there is a risk of ink leakage due to loosening of the ink bottle cap.
• Check to confirm that there is no foreign matter, such as paper towel scraps or dust,
adhering to the ink bottle caps. If foreign matter is present, this may block the ink path and
lead to leakage.
OK
Good example Bad example
40
No good