Registering Nozzle Recovery - MIMAKI TS100-1600 Operation Manual

Chapter 3 Settings
Item
Cleaning Type Normal/Soft/
Waste ink tank
Fill Up Ink
*1. The default settings are shown underlined.

Registering Nozzle Recovery

Allows other nozzles to be used for printing if maintenance actions like nozzle washing fail to resolve print
defects (e.g., nozzle clogging, deflection).
• Nozzle recovery can be specified for up to 10 nozzles per row. The time taken for printing
remains unchanged even when nozzle recovery is set.
• Load media at least 500 mm wide. You cannot print the entire pattern if media less than 500
mm wide is used.
1
Position the media.
2
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
3
Select [Nozzle Recovery] > [Print], then press the [ENTER] key.
4
Select the head for nozzle recovery, then press the [ENTER] key.
5
Select "Print Start", then press the [ENTER].
• Print a nozzle recovery pattern.
• The Select Entry Nozzle screen appears once printing is complete.
100 90 80 70 60
Approx. 300 mm
*1
Setting
• Cleans the print head. This will help prevent nozzle clogging.
Sets the cleaning type for head cleaning.
Hard
- Resets or corrects the waste ink tank usage count.
Tank Replacement"(P. 115)
- Fills the ink to resolve printing defects (e.g., nozzle clogging,
deflection).
50 40 30 20 10 0
H1-D K
H1-C Y
H1-B C
H1-A M
Details
10 5 0
401
301
201
101
1
No.203
78
"Waste Ink
H1-A M
Ink Color
Nozzle row number
Head number