MIMAKI TS100-1600 Operation Manual page 130

Chapter 5 Troubleshooting
Error Message
number
44f Take-up Roll Sns Err
48a Detect winding failure
504 CLAMP UP
505 Media Jam
509 HDC POSCNT
50a Y Org Detect Error
50c Check Media With
Sensor
50f L-SCALE BLACK
516 Media Set Position R
528 Pump Motor Sensor
549 LEnc. Count DIO
602 Ink End
608 Wrong Ink IC
64C NCU Error
Cause
• A problem was detected
with the take-up unit
sensor spindle.
• The take-up unit is unable
to take up media.
• The clamp lever is lifted.
• The media jam sensor
was triggered.
• A problem was detected
with position control.
• A problem was detected
with Y origin detection
(initialization).
• A problem was detected
with media width
detection.
• A problem was detected
with the linear scale.
• The media was loaded
outside the range of valid
positions.
• A problem was detected
with the pump motor.
• A problem was detected
with the linear scale wiring
to the DIO PCB.
• The ink has run out.
• An error occurred with the
information on the ink IC
chip.
• The function is disabled
due to an error.
130
Corrective action
1. Check to confirm the [Machine Setup] >
[ Feeding/Take-up] > [Take-up Unit]
setting is "ON".
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 56)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
unit"(P. 53)
• Check to confirm the media is
loaded correctly. "Loading the
Roll Media"(P. 56)
• Lower the clamp lever.
1. Remove the media in contact with the
carriage and reload with fresh media.
"Loading the media"(P. 53)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
• Turn off the power on the machine
and turn it on after a while.
1. Check the media loading position.
"Loading the media"(P. 53)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 98)
• Turn off the power on the machine
and turn it on after a while.
1. Check the media loading position.
"Loading the media"(P. 53)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 98)
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Replace with new ink.
"Replacing Ink"(P. 38)
1. Check to confirm the ink IC chip was
inserted correctly. "Registering the
Ink IC Chip"(P. 42)
2. Turn off the power on the machine and
turn it on after a while.
3. Replace with new ink.
Ink"(P. 38)
• Turn off the power on the machine
and turn it on after a while.
"Replacing