Correcting The Drop Position; Drop Position Correction Procedure - MIMAKI TS100-1600 Operation Manual

2.7 Correcting the Drop Position

Changing the media and print head height will also alter the drop positions. Correct the drop position to suit
the type of media used. Image defects (e.g., overlaid lines or blurred images) will result if the drop position is
not properly corrected.
• Was the print head adjusted?
• Is media loaded?
• Load media at least 500 mm wide. You cannot print the entire pattern if media less than 500
mm wide is used.

Drop Position Correction Procedure

Print a correction pattern, then enter the correction value. The value corrected here will also be updated on
the settings menu.
1
On the LOCAL mode screen, select [ADJUST].
2
Select [Drop.PosCorrect], then press the [ENTER] key.
3
Select the resolution and press the [ENTER] key.
• Select the resolution to be adjusted. When "All" is selected, correction patterns for all resolutions
will be printed.
• The indicated resolutions are those in the scan direction.
4
Check the print results.
• A correction value input screen appears.
• Enter the position where the two upper and lower lines coincide.
5
Enter the correction value, then press the [ENTER] key.
• Correction value: -40 to 40
Check beforehand
"Adjust Print Head Height"(P. 51)
"Loading the media"(P. 53)
LOCAL
ADJUST
"Setup menu"(P. 74)
In this case, the drop position correction value will be "+4.0".
width:1340mm
DATA CLEAR
Media feed direction
65
Chapter 2 Printing
2