MIMAKI TS100-1600 Operation Manual page 131

Error Message
number
650 NCU CONNECT
651 Replace NCU
652 NCU Nzk Chk (Hw)
653 NCU Nzk Chk (Mark)
654 NCU Center Pos
655 NCU Flush Pos
656 NCU SN Adjst
657 Replace NCU Ink Pad
658 NCU Sensor Lv Low
65b NCU Sens Adj Err H
65c NCU Sens Adj Err L
901 Operation Error
902 Data Remain
90d No Head Select
90f Print Area Short
b1b BaseIO PCB Vpow-s
b1c BaseIO PCB V24
b1d BaseIO PCB V24-A
b21 SLIDER1 PCB V3R3
b22 SLIDER1 PCB V2R5
b23 SLIDER1 PCB V1R8
b24 SLIDER1 PCB V1R2
d09 HD MEMORY [1234]
Cause
• A problem was detected
with the NCU connection.
• A problem was detected
with the nozzle clogging
assessment.
• A problem was detected
with the nozzle clogging
assessment.
• Printing position
adjustment failed.
• Sensor sensitivity
adjustment failed.
• The NCU ink absorber is
full.
• The sensor's sensitivity is
impaired.
• Sensor sensitivity
adjustment failed.
• The function is disabled
due to an error.
• Print (RIP) data was
received.
• A problem was detected
with the print head.
• The media is too small for
the print.
• A problem was detected
with the Base IO PCB
power supply.
• A problem was detected
with the slider PCB power
supply.
• A problem was detected
with head internal
memory.
131
Chapter 5 Troubleshooting
Corrective action
• The NCU must be replaced.
Contact your local distributor, our
sales office, or service center.
• Clean the NCU. "NCU
Cleaning"(P. 95)
• The NCU ink absorber must be
replaced. Contact your local
distributor, our sales office, or
service center.
• Clean the NCU. "NCU
Cleaning"(P. 95)
• Replace the NCU if the error does
not clear. Contact your local
distributor, our sales office, or
service center.
• Check the error details.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
• Turn off the power on the machine
and turn it on after a while.
• Replace with wider or longer media.
• If the printable area is reduced due
to a shift in the origin, move the
origin to increase the size of the
printable area.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
5