Problems Causing Messages To Appear; Warning Messages - MIMAKI TS100-1600 Operation Manual

5.2 Problems Causing Messages to
Appear
If a problem arises, the buzzer sounds and a message appears on the display.
You can also check the local guidance.
Take the appropriate action in accordance with the content of the message. If a message reappears even
after taking the prescribed action, contact your local dealer or our service office.

Warning Messages

Message
MOTOR POWER OFF
Replace NCU Ink Pad
REPLACE NCU
NCU Sensor Lv Low
NCU Sens Adj Err H
NCU Sens Adj Err L
NCU CONNECT
Ink Error
COVER OPEN
Lower the clamp lever
Data Remain
Temporary Suspension
Printing not possible/ink IC
NO MEDIA
Please load media.
"Displaying Machine Information (Local Guidance)"(P. 28)
Cause
• The motor stops due to
some action causing
initialization—for example,
opening the cover.
• The ink absorber needs to
be replaced.
• A problem was detected
with the nozzle clogging
assessment.
• The sensor's sensitivity is
impaired.
• Sensor sensitivity
adjustment failed.
• A problem was detected
with the NCU connection.
• An ink error occurred.
• The cover is open.
• The clamp lever is raised.
• Print (RIP) data was
received.
• Printing has been paused.
• An unusable ink IC chip is
used.
• No media is loaded, or the
sensors are faulty.
• No media is loaded, or the
sensors are faulty.
125
Chapter 5 Troubleshooting
Corrective action
• Wait until the initialization operation is
complete.
• The NCU ink absorber must be
replaced. Contact your local distributor,
our sales office, or service center.
• The NCU must be replaced. Contact
your local distributor, our sales office, or
service center.
• Clean the NCU. "NCU
Cleaning"(P. 95)
• Replace the NCU if the error does not
clear. Contact your local distributor, our
sales office, or service center.
• Turn off the power on the machine and
turn it on after a while.
• Check the ink error details.
Error"(P. 126)
• Close the cover.
• Lower the clamp lever.
"Front"(P. 20)
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
• Switch to REMOTE mode and resume
printing or clear the data and abort
printing.
• Replace with new ink and a new ink IC
chip.
• Load the media. "Loading the
media"(P. 53)
• Clean the media sensor.
Sensor Cleaning"(P. 98)
• Load the media. "Loading the
media"(P. 53)
"Ink
5
"Media