MIMAKI TS100-1600 Operation Manual page 82

Chapter 3 Settings
Item
LANGUAGE
Time Set -20 h to 0 to
UNIT / TEMP
UNIT / LENGTH
Key Buzzer
View Feed
Space Btwn PP.
Space Feed Mode Intermittent/
Network
Check IP
Address
Check MAC
Address
DHCP
AutoIP
IP Address
Default Gateway
DNS Address
Sub Net Mask
Event Mail
Mail Delivery
*1
Setting
• Standard: Select "Standard" if the medium is not detected
successfully.
English/ Sets the display language.
Japanese/
Chinese
Sets the current time and date. (With respect to JST)
+4 h
• This can be set within the range of -20 to +4 hours.
°C/°F Sets the display unit for temperature (Celsius/Fahrenheit).
mm/inch Sets the display units for length and area.
• Some items are displayed in "mm" even if "inches" is selected.
ON/OFF Sets an audible tone when keys are pressed.
• Audible signals indicating errors, warnings, and operation end
cannot be muted, even if "OFF" is selected for this setting.
ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
None/10 to The space between prints can be eliminated for continuous printing.
500 mm
• Reducing the space length may cause media sagging, resulting
in discrepancies in the distance the media is fed.
• Depending on the data size and number of passes in the feed
direction, the margins may be wider than the set value.
Alters the feed method for blank space included in the image data.
Continuous
• Intermittent: Uses intermittent feeding based on the timing of a
fraction of the pass.
• Continuous: Feeds forward by skipping blank parts.
- Sets the network address. The machine must be restarted to enable
this setting.
- Displays the machine's current IP address.
• It may take some time to determine the IP address. If the IP
address cannot be determined, the display will indicate "0.0.0.0".
- Displays the machine's current MAC address.
ON/OFF Select "ON" to use the IP address assigned by the DHCP server.
ON/OFF Select "ON" to use the IP address set by the AutoIP protocol. Note
that DHCP takes priority if DHCP is set to "ON".
- Sets the machine's IP address.
• This can be set when both [DHCP] and [AutoIP] are set to "OFF".
- Sets the machine's default gateway.
• This can be set when both [DHCP] and [AutoIP] are set to "OFF".
- Sets the machine's DNS server address.
• This can be set when both [DHCP] and [AutoIP] are set to "OFF".
- Sets the number of subnet mask digits used by this machine.
• This can be set when both [DHCP] and [AutoIP] are set to "OFF".
- An email can be sent to a specified email address when an event
(e.g., print start, print end, and abort) occurs. The machine must be
restarted to enable this setting.
Settings"(P. 84)
ON/OFF Sets whether event emails are sent.
Details
"Event Email Function
82