Chapter 4 Maintenance
5
Press the [ENTER] key once cleaning is complete.
• "Cap Cleaning Completed (Next) [ENT]" appears on the display.
6
Clean the cap rubber.
•
"Cap Rubber Cleaning"(P. 94)
7
Once cleaning is complete, close the cover, then press the [ENTER] key.
• The cap is filled with maintenance liquid.
• Close the front cover. The cap cannot be filled with maintenance liquid unless the front
cover is closed. This is also true if the maintenance liquid cartridge is empty.
8
Open the front cover.
• Check to confirm that the cap is filled with maintenance liquid.
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
9
Close the front cover.
10
Set the exposure time, then press the [ENTER] key.
• Print nozzle washing starts. The elapsed time is displayed on the display.
• Cleaning is performed automatically once print nozzle washing has ended.
• The cap is filled with maintenance liquid.
• Close the front cover. The cap cannot be filled with maintenance liquid unless the front
cover is closed. This is also true if the maintenance liquid cartridge is empty.
11
Open the front cover.
• Check to confirm that the cap is filled with maintenance liquid.
102