MIMAKI TS100-1600 Operation Manual page 129

Error Message
number
171 NEW HEAD CONNECT
18a Main PCB V_CORE
18b Main PCB V1R5B
18c Main PCB V12
18e FLS NOT COMP
18f OFSET START
18f OFSET END
1e6 PRAM Size Shortage
201 Command Error
202 Parameter Error
206 Printing Mode
20A Driver Version
304 USB INIT ERR
305 USB TIME OUT
307 MCFD File IF Error
401 Motor X
402 Motor Y
403 X Current
404 Y Current
406 Wiper Move Failure
Cause
• A new print head
connection was detected.
• A problem was detected
with the main PCB power
supply.
• A problem was detected
with the print head control.
• Insufficient memory
• Data other than print (RIP)
data was received, or a
problem was detected
with the print (RIP) data
received.
• A problem was detected
with the print (RIP) data
received.
• Print (RIP) data was
received with print
parameters that do not
allow printing.
• Printing is not possible
because the Mimaki driver
version is old.
• A problem was detected
with the USB cable
connection.
• A problem was detected
while accessing print
parameter data.
• The X motor was
overloaded.
• The Y motor was
overloaded.
• An overcurrent error was
detected in the X motor.
• An overcurrent error was
detected in the Y motor.
• Wiper-origin could not be
detected.
129
Chapter 5 Troubleshooting
Corrective action
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
1. Clear the data and resend.
2. Check the USB cable connection.
"Using a USB Cable"(P. 31)
3. Use a compliant USB cable.
Connection Precautions"(P. 31)
4. Turn off the power on the machine and
turn it on after a while.
• Change the output parameters and
profile using RIP software.
• Install the latest Mimaki driver
available from:
https://mimaki.com/download/
inkjet.html
1. Check the USB cable connection.
"Using a USB Cable"(P. 31)
2. Use a compliant USB cable.
Connection Precautions"(P. 31)
3. Turn off the power on the machine and
turn it on after a while.
• Turn off the power on the machine
and turn it on after a while.
1. Check to confirm the media is loaded
correctly. "Loading the
media"(P. 53)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
3. Turn off the power on the machine and
turn it on after a while.
1. Clean the wiper and around the wiper.
"Wiper Cleaning"(P. 92)
2. Turn off the power on the machine and
turn it on after a while.
"USB
"USB
5