MIMAKI TS100-1600 Operation Manual page 83

Item
Setting
Select Event
Print Start
Event
Print End
Event
Plot Start
Event
Plot End
Event
Error
Warning
Other Event
Mail Address
Message Subject
Server Setup
SMTP
Address
SMTP Port
No.
Sender
Address
Authentication OFF/POP
before SMTP/
authentication
User Name
Pass Word
POP3
Address
APOP
Transmit Test
Auto Remote
Feeding Before Cut
*1
-
ON/OFF Sets whether an email is sent when printing starts.
ON/OFF Sets whether an email is sent when printing ends.
ON/OFF Sets whether an email is sent when cutting starts.
ON/OFF Sets whether an email is sent when cutting ends.
ON/OFF Sets whether an email is sent when an error occurs.
ON/OFF Sets whether an email is sent when a warning occurs.
ON/OFF Set to send or not send an email when an event other than those
listed above occurs.
- Sets the email address to which emails will be sent (not to exceed 96
alphanumeric characters or symbols).
- Sets the characters contained in a message subject (not to exceed 8
alphanumeric characters or symbols).
-
- Sets the SMTP server.
- Sets the SMTP port number.
- Sets the sender address (not to exceed 64 alphanumeric characters
or symbols).
• Setting an email address corresponding to the server account
allows emails to be sent.
Sets the SMTP server authentication method.
SMTP
- Sets the user name used for authentication (not to exceed 30
alphanumeric characters or symbols).
• This can be set when [Authentication] is not set to "OFF".
- Sets the password used for authentication (not to exceed 15
alphanumeric characters or symbols).
• This can be set when [Authentication] is not set to "OFF".
- Sets the POP server.
• This can be set when [Authentication] is set to "POP before
SMTP".
- Enables or disables APOP.
• This can be set when [Authentication] is set to "POP before
SMTP".
- Sends a test email.
ON/OFF Sets whether to automatically switch to REMOTE mode and start
printing if data is received locally.
ON/OFF Sets whether to feed media before cutting the media.
Details
"Transmit Test"(P. 84)
83
Chapter 3 Settings
3