Machine Setup Menu - MIMAKI TS100-1600 Operation Manual

3.3 Machine setup menu

This is used to set various operations to ensure optimal machine performance.
l Menu List
Item
Auto Power-off None/5 min to
15 min to 600
Auto Power-on
SETUP
Time 0:00 to 23:59 Sets the time to turn on the power.
Day of week
Nozzle check
Cleaning Soft/Normal/
Retry Count 0 to 3 times
Take-up Unit
Take-up Unit
Take-up SW Continuous/
Temporary
Top blower
STRENGTH AUTO/Weak/
Media Remain
Media Detect
DETECTION
TYPE
At Startup
Detect Speed Fast/Standard
*1
Setting
Sets the time until the power is automatically turned off.
min
- Sets the time to automatically turn on the power.
ON/OFF Sets whether to turn on or off the power.
- Sets whether to turn on or off the power on each day of the week.
ON/OFF Automatically executes the nozzle check function when the machine
is started with auto power-on. Performs nozzle recovery (cleaning
followed by nozzle checking) if "nozzle clogging" is detected.
Sets the cleaning type.
Hard
Performs nozzle recovery (cleaning followed by nozzle checking) for
the specified number of times.
- Sets the take-up unit operation.
ON/OFF Set to "OFF" if the take-up unit is not used.
Sets the function performed by the ON/OFF button on the take-up
unit in LOCAL mode.
• Continuous: Press the button to start/stop the take-up unit.
• Temporary: The take-up unit operates only while the button is
pressed. The unit stops when the button is released.
ON/OFF Sets the blowing fan operation during printing.
Sets the blowing fan wind strength.
Standard
ON/OFF The remaining roll media amount can be displayed and printed out in
REMOTE mode.
• ON: An input screen appears once the media width is detected.
Press
Press the [FUNC3] key on the "Origin Setup" screen to print the
date and remaining media amount.
• OFF: The remaining media amount is not displayed.
- Sets the media width detection method.
AUTO/ • AUTO: The media width is automatically detected with the
MANUAL sensor.
• MANUAL:
– When using media that cannot be detected using AUTO, set to
"MANUAL".
ON/OFF The medium is detected automatically when the clamp lever is
lowered after the machine starts up. Set to "OFF" if auto detection is
not required.
• Fast: Clear or reflective media may not be detected. If detection
is unsuccessful, select "Standard".
Details
to set the media length.
Press to set the media width manually.
81
Chapter 3 Settings
3