MIMAKI TS100-1600 Operation Manual page 41

4
Use the tightening jig to tighten the ink bottle caps in place.
Tightening tool
1 2
• Do not overtighten the ink bottle caps. Disregarding this precaution may result in damage,
idling or ink leakage. If the arrow goes beyond the range indicated above, loosen the
bottle cap, and repeat the steps again.
5
Turn the ink bottle upside-down to check that no ink leaks occur.
l Mounting the Ink bottle
The order of Ink bottle to be set depends on the ink set you are currently using. Check the ink slot numbers,
then insert the correct color Ink bottle.
Ink set
4-color
[SPA-0232] Good example
Position the upper
arrow within this
range!
[SPA-0328] Good example
Position the upper
arrow within this
range!
Ink bottle positions (specified by color)
1
M
41
Chapter 1 Before Use
Bad example
Bad example
2 3
BL Y
1
4
K