Table of Contents
Advertisement
Commissioning
7.2.2
Establish communication PMCprimo C with PC
The following steps describe how to establish a connection between the PC and motion
controller via the Ethernet interface.
Prerequisite:
The motion controller PMCprimo C must be installed in a servo amplifier PMCprot-
}
ego D.
The commissioning software PASmotion is installed on the PC.
}
The supply voltages (24 VDC) must be present on the servo amplifier and PM-
}
Cprimo C.
The configuration PC must be connected to the Ethernet interface X43 on the PM-
}
Cprimo C.
Establish connection
1. Start the commissioning software PASmotion.
2. Select the Terminal window.
3. Click on the
The Connection Settings window opens.
You can now connect to a known network subscriber. If you do not know the IP address,
you can browse the network for subscribers.
Alternative 1: The IP settings are known
Prerequisite: The PMCprimo C and PC must be in the same network or be accessible
}
via a Router.
1. Select Ethernet.
The New Connection window opens.
2. Enter the IP address in the connection settings and select Finish.
The connection to the PMCprimo C is established.
Alternative 2: The IP settings are unknown
Prerequisite: The PMCprimo C and the PC are in the same broadcast domain.
}
1. Select Ethernet.
2. From the list, select the subscriber to which you wish to connect.
Note: Click on Ping to identify the device's hardware.
3. Select Configuration... The Device Configuration window opens.
4. Enter the IP settings and then select Use this IP address. The Connection Wizard
window opens.
5. Select Finish.
The network subscriber is connected.
Operating instructions PMCprimo C
1002242-EN-03
icon - Create New Connection.
40
Advertisement
Table of Contents
