Matrix
What's this?
• Every system comes with pre-defined set of variables like number
list, timers and other parameters. These pre-defined settings are
called default settings.
• The default value of each programmable parameter is mentioned in
the respective section. If the default setting suits your requirement
then, you may not even require programming the system and the
system will work with the default settings.
When to use it?
Many times it happens that due to some programming error, the
system goes haywire and you are unable to analyze the problem.
During such a situation, it is advisable to default the system. However,
software default of the system can be done from the programming
mode and hence programming password should be known. If you
forget the password default cannot be done and in that case
hardware default of the system should be done. For this, refer chapter
'Configuring the System'.
How to program?
Use the following command to assign default configuration to the
system:
201-Reverse SE Password-#*
Where,
SE Password is of 4 digits ranging from 0000 to 9999.
By default, SE Password is 1234.
The following are the parameters, which will not default when the
system is default:
• CDR Buffer
• Real time Clock (RTC)
• Call Progress Tone Generation Type
• Mobile SIM PIN
Relevant Topics:
1. Getting Started 24
2. Programming the System
72
Default the Configuration
115
=X=X=
SIMADO GBR42 V1 System Manual
Need help?
Do you have a question about the SIMADO GBR42 and is the answer not in the manual?