Matrix Telecom SIMADO GBR42 System Manual page 28

Matrix
Before switching ON install the SIM card as mentioned below:
SIM PIN
Before switching ON the gateway, install the SIM card as mentioned
below:
• Whenever the SIM PIN request is received from the module, the
system will send the SIM PIN stored in the configuration to the
module. Hence it is necessary that the SIM PIN in the SIM card
and in the system is same.
• If required the parameters, 'SIM PIN' and 'SIM PIN at Power On
flag' can be changed in the SIM card by removing the SIM card
from the gateway, inserting it into the mobile handset and
changing it from mobile handset.
• User should enable the 'SIM PIN at power ON' parameter in the
SIM card to protect the SIM card that is inserted in the system
from being mis-used.
• Now if SE tries to change the SIM PIN, on receipt of command
for SIM PIN change, the system will first send the command to
the module. If the 'SIM PIN at Power On flag' is enabled in the
SIM card, the change would be effective.
• If 'SIM PIN at Power ON flag' is disabled in the SIM card, the
change would not be effective. User can know this change in the
SIM PIN by downloading the SIM PIN page of 'Jeeves'.
• Hence, the 'SIM PIN at Power ON flag' in the SIM card must be
enabled. Otherwise, SIM PIN will not be changed using the
command for 'Changing SIM PIN'.
Important Points:
• Ensure that the SIM PIN in the SIM card and in the system is
same. By default, SIM PIN for all the ports of the system is 1234.
• To protect the SIM card that is inserted in the system from being
mis-used, the customer is recommended to enable 'SIM PIN at
Power ON' parameter in the SIM card.
• Ensure that the 'SIM PIN at Power On' parameter in the SIM card
is enabled to change the SIM PIN.
Switching ON
• Switch ON the power for Adaptor. The system will take about 1-2
minutes to reset.
28 SIMADO GBR42 V1 System Manual