Matrix Telecom SIMADO GBR42 System Manual page 171

To assign hardware port to the TE port
To program First Digit Wait Timer for TE Port
To program the Inter Digit Wait Timer for TE Port
To program the ISDN Switch Variant for a TE Port
To prg. the OG Digit dialing method for the TE port
To initialize, if SPID is used
To program overlap receiving timer for TE port
To assign an idle channel code for TE logical Port
To assign the Type of network to TE Port
To program the DDI pilot number for the TE Port
To program the Start DDI Number for the TE Port
To program the total DDI Number for the TE Port
To program the DDI Number of Digits for the TE Port
To allow/deny incoming calls for the TE Port
To enable/disable DID on TE port
To program Called Party TON for TE port
To program Called Party NPI for TE port
To program Calling Party TON for TE port
To program Calling Party NPI for TE port
To select TEI Negotiation on the TE port
To program TEI Neg. value for the fixed TEI Neg. Mode 423-TE Port-Value-#*
Time Table
To program start/stop time for TZ in time table
To assign time table to the Mobile port
To assign time table to the TE port
To assign time table to the NT port
SIMADO GBR42 V1 System Manual
402-TE Port-BRI Port-#*
403-TE Port-First Digit Wait Timer-#*
404-TE Port-Inter Digit Wait Timer-#*
405-TE Port-ISDN Switch Variant-#*
406-TE Port-Code-#*
407-TE Port-SPID Number-#*
409-TE Port-Overlap Rec.Timer-#*
410-TE Port-Idle Code-#*
411-TE Port-Code-#*
412-TE Port-DDI Pilot Number-#*
413-TE Port-DDI Start Number-#*
414-TE Port-Total DDI Number-#*
415-TE Port-DDI Number of Digits-#*
416-TE Port-Code-#*
672-TE Port-Code-#*
418-TE Port-Called Party TON-#*
419-TE Port-Called Party NPI-#*
420-TE Port-Calling Party TON-#*
421-TE Port-Calling Party NPI-#*
422-TE Port-TEI Negotiation Mode-#*
105-Time Table-TZ-Start Time-End Time-#*
106-Mobile Port-Time Table-#*
107-TE Port-Time Table-#*
108-NT Port-Time Table-#*
Matrix
171