Matrix Telecom SIMADO GBR42 System Manual page 60

Matrix
Ca lling
Inde x
Num be r
001
Note
:
:
200 Blank
Note : The first row of the Table contains routing parameters used
1
when No match is found with Calling Numbers programmed
in the table and is not programmable.
• CLI based routing option is not applicable for NT port.
• But CLI based routing option can be used for Mobile and TE port.
How to program?
Step 1: To program the CLI Number String using the command 131.
Step 2: To program the Routing Group for a CLI number using the
command 132.
Step 3: To program the Change Called Number flag using the
command 133.
Step 4: To program the new called number at an index in the CLI
routing table using the command 134.
Step 5: To clear entire CLI Based routing Table using command 135.
Step 1
Use following command to program the CLI number string:
131-CLI Routing Table Index-CLI Number String-#*
Where,
CLI Routing Table Index is from 002 to 200. Index 001 is reserved for
default parameters for the case of routing if CLI is not matching.
CLI Number String is of maximum 16 digits. Number string ranges
from 0-9, #, * and +.
By default, CLI Number String is Blank.
Use following command to clear number string at an index in the CLI
routing table:
131-CLI Routing Index-#*
60
Routing
Group
1
01
: :
: :
01
Cha nge Ca lle d
Num be r?
Yes
:
:
Yes
SIMADO GBR42 V1 System Manual
Ne w
Ca lle d
Num be r
Blank
:
:
Blank