Programming The System - Matrix Telecom SIMADO GBR42 System Manual

Table of Contents

Advertisement

What's this?
• SIMADO GBR42, supports two methods of programming:
• Programming with analog phones, connected at NT ports.
• Programming using Jeeves. Refer chapter Jeeves for this.
• This chapter explains how to enter programming mode for applying
various commands.
• You can enter the programming mode:
• From NT port directly (by dialing the command to enter System
Engineer (SE) mode).
• From TE/Mobile port if DID is enabled.
How to use it?
1
Lift the handset.
2
Dial *-19-S E Password.
To exit SE Mode, Dial 00-#*.
Use following command to change the SE Password:
211-New SE Password-#*
Where,
New SE Password is a number string of maximum 4 digits.
Important Points:
• While in programming mode if you go ON-Hook you will come out
(exit) from the SE Mode. You will have to enter SE Mode again,
to restart programming.
• The command is accepted even during confirmation tone.
• You will get programming tone on expiry of the confirmation tone.
Relevant Topics:
1. Jeeves 94
2. Routing Type 131
3. Default the Configuration
4. Communication Port
5. Configuring the System
SIMADO GBR42 V1 System Manual

Programming the System

72
65
16
=X=X=
Dial tone
P rogram m ing tone
Matrix
115

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SIMADO GBR42 and is the answer not in the manual?

Table of Contents