Matrix Telecom SIMADO GBR42 System Manual page 109

Where,
NT Port is from 1 to 2.
Idle Code is from 000 to 255.
Most commonly applicable values are 7F and FF (Binary equivalent is
0111 1111 and 1111 1111, decimal equivalent is 127 and 255).
By default, Idle Code is 127 (7F).
Step 7
• This gives option for allowing or denying the Incoming calls on this
Port.
• If this option is set to "Deny", the port can not be used as source
port as all the call originating on this port will get rejected.
• If this option is set to "Allow", the port can be used as source port.
All the calls originating on this port will get routed based on the
programming.
• If this port is 'Destination Port' this command is not applicable.
Use following command to allow or deny the Incoming Calls for NT
Port:
511-NT Port-Code-#*
Where,
NT Port is from 1 to 2.
Code Meaning
0 Deny
1 Allow
By default = 1 (Allow).
Note:
• Port must be 'enabled' to allow/deny IC Calls.
Step 8
Use following command to program 'Called party TON' for NT port:
513-NT Port-Called Party TON-#*
Where,
NT Port is from 1 to 2.
Called Party TON is from 1 to 7.
SIMADO GBR42 V1 System Manual
Matrix
109