ProSoft Technology ControlLogix inRAx MVI56E-MNETR User Manual page 85

MVI56E-MNETR ♦ ControlLogix Platform
Modbus TCP/IP Interface Module with Reduced Data Block
MNETRCMDCONTROL
When the command bit
(MNETR.CONTROL.C
ladder logic, the module will build a block 9901 with the number of commands set
through: MNETR.CONTROL.C
The command indexes will be set through the controller tags starting from
MNETR.CONTROL.C
MNETR.CONTROL.C
For example, in order to enable commands 0, 2 and 5 the following values would
be set:
MNETR.CONTROL.C
MNETR.CONTROL.C
MNETR.CONTROL.C
MNETR.CONTROL.C
The module will receive this block and build and send the command to the
specified control device using a MSG block.
The following table describes the data for the command element in
MNETRCmdControl.
Name
CmdIndex
NumberOfCommands
CommandsAddedtoQueue
CmdControlTrigger
ProSoft Technology, Inc.
June 14, 2011
C .C C
MD ONTROL MD ONTROL
C
MD ONTROL
C .C I
MD ONTROL MD NDEX
C .C I
MD ONTROL MD NDEX
C .C
MD ONTROL MD
C .C
MD ONTROL MD
C .C
MD ONTROL MD
C .C
MD ONTROL MD
Data Type
INT[6]
INT
INT
BOOL
) is set in the example
T
RIGGER
.N O C
UMBER F OMMANDS
[0] to
[5]
I [0] = 3
NDEX
I [1] = 0
NDEX
I [2] = 2
NDEX
I [3] = 5
NDEX
Description
The position of the initial command to execute
from the Client command list.
The number of commands to execute from the
Client command list
Number of commands added to queue
Trigger Command Control. User application
will activate this trigger.
Ladder Logic
User Manual
[0].
Page 85 of 175