Capture App
Port: Specify a port number to capture only
traffic from that UDP or TCP port. For example,
select port 80 to capture HTTP traffic only.
NOT: Touch the toggle to enable this setting,
which directs the EtherScope NOT to capture
the values you have entered in the filters above.
For example, if you have set up a filter to
capture traffic to and from IP 10.250.0.70 on
Port 80 and you enable NOT, all traffic is
captured except traffic to and from 10.250.0.70
on port 80.
Wi-Fi Filters
Channel: Tap the channel button to set the
channel on which packets are captured.
Channel Width: This setting appears if you have
selected a Channel number in the 5-GHz band
(above channel 14). Tap to select a 20, 40, or 80
MHz width.
BSSID/MAC: Enter a BSSID to capture only
packets going to or from the target device.
Control, Data, and Management Frames and
Beacons: All frame types are captured by
default. Tap the toggle button for each frame
type to disable its capture.
Back to Title and Contents
392
Need help?
Do you have a question about the EtherScope nXG Controlled Edition and is the answer not in the manual?