netAlly EtherScope nXG Controlled Edition User Manual page 25

Introduction
To charge with PoE, connect the top RJ-45 port
on the unit to a network switch with PoE or a
PoE injector. The following conditions must be
met for the unit to charge with PoE:
The unit must be powered on or in display
sleep mode.
The Charge Battery via PoE setting must be
enabled in General Settings.
The EtherScope must also run an AutoTest
Wired Profile with a passing PoE test to detect
PoE availability, meaning the PoE Test must be
enabled and configured with a Powered Device
Class that is supported by your switch or PoE
Injector. See Wired Profile Settings and Results.
25