Charging And Power; Poe Charging - netAlly EtherScope nXG Controlled Edition User Manual

Introduction

Charging and Power

Your EtherScope nXG Controlled Edition
includes a USB-C 15V/3A power adapter.
CAUTION: Only the NetAlly-supplied power
W
adapter is supported.
To begin charging the internal Lithium Ion
battery, plug the included power adapter into
an AC outlet and the USB-C charging port on
the left side of the unit. The Power LED button
turns red when the unit is in charging mode
and turns off at full charge. The unit fully
charges in 2-4 hours via AC power.
When in charging mode (meaning the unit is off
but plugged into an AC power source), the unit
turns on once every 24 hours and top off the
battery charge, then power off again.
Tap the power button briefly to view the
battery level on the screen while the unit is in
charging mode.
When on battery power only, the unit runs for
3-4 hours, depending on the type of testing
being conducted.

PoE Charging

Power over Ethernet (PoE) is also convenient
24