Table of Contents
Advertisement
negotiation to succeed. If the UPOE Class is
selected on your EtherScope but LLDP is
not enabled on your Cisco switch, nego-
tiation fails.
LLDP
This toggle button appears if Class 4 (25.50 W) is
selected. Enable this setting if LLDP is enabled
on the switch you are testing. Class 4 LLDP
must be enabled on the switch for AutoTest to
detect it successfully. If the LLDP setting is
enabled but your switch does not support
LLDP, negotiation fails.
Requested Power (W)
This setting appears if UPOE is selected in the
Powered Device Class setting shown above or if
the Powered Device Class is set to PoE Injector
and TruePower is enabled. Touch to enter a
Requested Power other than the default, if
needed. If you touch the backspace button on
the pop-up number pad and clear the default
value, the valid power range is displayed.
AutoTest App and Profiles
230
Advertisement
Table of Contents
Need help?
Do you have a question about the EtherScope nXG Controlled Edition and is the answer not in the manual?
Questions and answers