Huawei NetEngine80E Installation Manual page 58

HUAWEI NetEngine80E Router
Installation Guide
3.4.3 Installing Ethernet Adapters
This section describes how to install Ethernet adapters.
Installing a Shielded Ethernet Connector
This section describes how to install a shielded Ethernet connector.
Procedure
Step 1 Hold the male and female connectors, with the male connector facing the female connector, as
shown in
Figure 3-53 Holding the male and female connectors
Step 2 Insert the male connector into the female connector, as shown in
Figure 3-54 Feeding the male connector into the female connector
Step 3 Pull the connector slightly and ensure that it is securely connected.
Issue 02 (2011-09-10)
Figure 3-53.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 On-site Cable Assembly and Installation
Figure 3-54.
50