Huawei NetEngine80E Installation Manual page 48

HUAWEI NetEngine80E Router
Installation Guide
Figure 3-36 Skew plastic separators
Step 5 Hold the connector with the side facing towards you, and check whether you can see the cross-
sections of the wires. Ensure that the ends of the wires are in good contact with the edge of the
RJ45, and that the contact strip blade extends beyond the ends of the wires and is crimped with
the wires. If not, replace the connector.
Figure 3-37 Wires not in good contact with the edge of the RJ45
----End
3.3.4 Testing the Connection of Assembled Cables
This topic describes how to test an assembled Ethernet cable, ensuring that the connectors and
wires at both ends are correctly connected. This topic illustrates how to test a straight-through
cable.
Context
Huawei provides two types of Ethernet cables: straight-through cables and crossover cables.
l
Issue 02 (2011-09-10)
Straight-through cables are connected in a one-to-one manner. They are used to connect
terminals such as a computer to network devices.
wires in a straight-through cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 On-site Cable Assembly and Installation
Figure 3-37 shows an unqualified piece.
Table 3-7 lists the connections of core
40