Huawei NetEngine80E Installation Manual page 39

HUAWEI NetEngine80E Router
Installation Guide
Procedure
Step 1 Fit the jacket of the connector onto the Ethernet cable, as shown in
Figure 3-16 Fit the jacket of the connector onto the Ethernet cable
Step 2 Remove a 30-mm (1.18–in.) long section of the jacket, cut off the nylon twine inside the jacket,
and cut a 5-mm (0.20–in.) cleft in the jacket, as shown in
l When you remove a section of the jacket, do not damage the shield layer of the twisted-pair
l When you remove the shield layer, do not damage the insulation of the twisted-pair cable.
Figure 3-17 Removing the jacket of a twisted-pair cable (unit: mm (in.))
Step 3 Fit the metal shell onto the twisted-pair cable. The shield layer is covered by the metal shell, as
shown in
Issue 02 (2011-09-10)
CAUTION
cable.
Figure 3-18.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 On-site Cable Assembly and Installation
Figure 3-16.
Figure 3-17.
31