Huawei NetEngine80E Installation Manual page 57

HUAWEI NetEngine80E Router
Installation Guide
l Ensure that the exposed section of the terminal should be less than 2 mm in length, as shown
l Do not press the insulation of the terminal.
l Insert only one terminal into one jack.
Figure 3-51 Exposed section of the terminal
Step 3 Move the cable slightly and ensure that it is securely connected, as shown in
Figure 3-52 Installed cord end terminal
Step 4 Before you remove a cord end terminal, loosen the screw in the counterclockwise direction.
----End
Issue 02 (2011-09-10)
CAUTION
in Figure 3-51.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 On-site Cable Assembly and Installation
Figure 3-52.
49