Huawei NetEngine80E Installation Manual page 144

HUAWEI NetEngine80E Router
Installation Guide
Power Cable Label
Remove the label from the backing page, and attach it to the identification plate on the cable tie.
The label should be attached to the rectangular flute on the identification plate, and attached to
only one side of the identification plate. The cable ties are bundled at 2 cm (0.79 in.) from the
connectors, and other positions are allowed in special circumstances.
Cable ties should be bound on both ends of a cable. After the bundling, the finished identification
plate should be on top of the cable in horizontal cabling, or on the right side of the cable in
vertical cabling, as shown in
l
l
Issue 02 (2011-09-10)
Figure D-6 Label for signal cables
The identification card is to the right of the cable in vertical cabling.
The identification card is on the top of the cable in horizontal cabling. Make sure that the
label is facing out.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure D-7. The details are as follows:
D Engineering Labels for Cables
136