Huawei NetEngine80E Installation Manual page 109

HUAWEI NetEngine80E Router
Installation Guide
A.3 List of LPU Interface Attributes
This chapter presents the list of LPU Interface Attributes.
A.3.1 Interface Attributes of 10Base-T/100Base-TX/1000Base-T-RJ45
Table A-4
Table A-4 Interface attributes of the 10Base-T/100Base-TX/1000Base-T-RJ45
Attributes
Connector type
Working mode
Cable specification
Frame format
Network protocol
A.3.2 Interface Attributes of 100Base-FX
Table A-5
Table A-5 Attributes of 100M SFP optical modules
Attributes
Transmission
distance
Center wavelength
Minimum
transmitting power
Maximum
transmitting power
Receiving
sensitivity
Overload power
Optical fiber type
Issue 02 (2011-09-10)
lists the interface attributes of 10Base-T/100Base-TX/1000Base-T-RJ45.
Description
RJ45
10M/100M/1000M auto-sensing and half-duplex and full-duplex
When the interface rate is 10 Mbit/s or 1000 Mbit/s, Category 5
unshielded twisted pair (UTP) cable is recommended. When the
interface rate is 1000 Mbit/s, Super category 5 Shielded Twisted
Pair (STP) cable is recommended.
Ethernet_II, Ethernet_SAP, and Ethernet_SNAP
IP
lists the interface attributes of 100Base-FX.
Description
2 km ( 1.24
mi )
1310 nm
-19.0 dBm
-14.0 dBm
-30.0 dBm
-14.0 dBm
Multi-mode
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 km ( 9.32 40 km ( 24.86
mi ) mi )
1310 nm 1310 nm
-15.0 dBm -5.0 dBm
-8.0 dBm 0 dBm
-31.0 dBm -37.0 dBm
-8.0 dBm -10.0 dBm
Single-mode Single-mode
A Parameters
80 km ( 49.71
mi )
1550 nm
-5.0 dBm
0 dBm
-37.0 dBm
-10.0 dBm
Single-mode
101