Connect Novocyte Workstation; Connect Novocyte Fluidics Station Ii - Agilent Technologies NovoCyte Quanteon Operator's Manual

Installation
Any peripheral accessories connected to NovoCyte Quanteon instrument
WARNING
need to meet SGS requirements outlined in UL 61010-1 and CAN/CSA-C
22.2 No. 61010-1-12 Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use — Part 1: General Requirements.

Connect NovoCyte Workstation

1 Connect the workstation to the monitor using the included DisplayPort to Mini
DisplayPort cable (Connection A in Figure 23). Connect the DisplayPort end of
the cable to the back of the workstation. Connect the Mini DisplayPort end to
the monitor.
2 Connect the mouse and keyboard to any of the USB ports on the back of the
workstation.
3 Use the supplied USB cable to connect the NovoCyte Quanteon flow
cytometer to the USB port of the NovoCyte workstation (Connection D in
Figure 23).
There are four communication ports at the back of NovoCyte Quanteon instrument
NOTE
(see Figure 24). COM 1 port connects to the NovoSampler Q (optional). COM 1 port
connects to the NovoSampler Q (optional). USB port connects to the NovoCyte
Workstation. COM 2 port connects to the NovoCyte Fluidics Station II through a DVI
cable. The NET port is reserved for network connection.
Figure 24. NovoCyte Quanteon Instrument Communication Ports
4 Connect the workstation and monitor to the power supply (Connections B and
C in Figure 23). For more details, please refer to the instructions from the
computer and monitor supplier.

Connect NovoCyte Fluidics Station II

NovoCyte Fluidics Station II is connected to the COM 2 port of the NovoCyte
Quanteon instrument through the supplied DVI cable (Connection E in Figure 23).
The connections for the reagent containers to the NovoCyte Quanteon instrument
are shown in Figure 25. Five sets of tubing connect reagent containers on the
54 NovoCyte Quanteon Flow Cytometer Operator's Guide