Installation Guide Getting Started Getting Started Remove the screw from the rear tab on the accessory pouch. Slide the tabs on the front of the accessory pouch into the recessed holes on top of the oscilloscope. Rotate the rear of the accessory pouch down and insert the tab at the rear of the accessory pouch into the slot at the rear of the oscilloscope cabinet.
Page 3
Installation Guide Loading the Printer Paper Lightly push up on the front of the paper cover with your thumb and rotate it toward the back of the printer. Push the tip of the paper into the inlet at the bottom of the paper holder, until the auto-loader catches it and feeds about 10 cm through the paper cutter.
0 °C to 40 °C (32 °F to 104 °F) Humidity 30% to 80% RH (non-condensing) Paper Reorder • Seiko #TP411-28CL (TP-411L) (1 roll) • Agilent Technologies N2728A (10 rolls) Additional printer information Refer to the supplied Seiko Operation Manual for additional printer information.