Service, Maintenance And Cleaning; Safety Instructions For Service, Maintenance And Cleaning - Planmeca PlanMill 50 S User Manual

10 Service, maintenance and cleaning

10 Service, maintenance and cleaning

10.1 Safety instructions for service, maintenance and cleaning

76 Planmeca PlanMill 50 S
Personnel required: Specialist personnel / manufacturer
Protective equipment required: Protective work clothing, protective gloves,
safety footwear, respiratory protection, safety goggles.
WARNING
Risk of injury due to a lack of diligence! Before performing cleaning,
maintenance and servicing work, switch off the milling unit's main switch and
unplug the mains plugs in order to prevent the milling unit being switched on
accidentally (establish safe milling unit state)!
• Only use suitable climbing aids for cleaning, maintenance or servicing!
• Wear protective gloves and safety goggles as a general risk of injury
exists due to sharp-edged or pointed chips!
CAUTION
Risk of injury due to sharp-edged or pointed milling tools!
WARNING
Risk of injury and death when reaching into the milling unit interior due to
sharp- edged or pointed tools!
Be aware of protruding tools!
Always wear protective gloves when reaching into the milling unit's interior!
WARNING
Risk of injury due to sharp-edged or pointed chips!
Risk of injury when reaching into the milling unit's interior. The chips inside
may be sharp- edged or pointed and could cause deep cuts or injuries!
Always wear protective gloves and safety goggles when cleaning the milling
unit!
WARNING
Danger of explosion and fire!
The combination of oil mist and air can produce a highly explosive mixture!
Therefore refrain from blowing out the milling unit with compressed air or
oxygen and avoid naked flames (smoking)! When cleaning the milling unit
never use flammable cleaning products. These can cause a milling unit fire
during operation, maintenance or servicing!
NOTE
Cleanliness increases the service life of the individual components and
prevents malfunctions. Therefore clean the milling unit regularly with a hand
brush, paintbrush or vacuum cleaner. Ensure that no dirt penetrates the
milling unit mechanism.
User's manual