Planmeca PlanMill 50 S User Manual page 72

9 Control software
Symbol
66 Planmeca PlanMill 50 S
Designation
Program stop
Reset control
Reference run
Drive to service position
Extraction system on / off If an extraction system is properly connected with the
Cooling liquid on / off
Purging on / off
Description
Using this button, currently executed milling
programs are stopped and the milling unit drives
directly back into the "home position".
With an error the control can be reset with this. It is
subsequently necessary to perform a reference run
again.
With this it is possible to start the system referencing
manually.
The milling cutter in the spindle is placed in its
assigned tool position.
The milling unit subsequently drives into the service
position. The collet chuck opens and a window
displays (see the Service position window below).
This function is primarily suitable for free access to
the collet chuck for cleaning. Once the service work
is complete, close the lid on the milling unit again.
After selecting a tool position and confirming it, the
milling unit automatically picks up the corresponding
tool in the collet chuck and measured it.
milling unit via a control cable, it can be switched on
and off manually using this button.
In automatic mode the extraction system is switched
on and off automatically with dry processing.
The cooling liquid flow is switched on or off. During
automatic operation, the cooling liquid flow is
switched on and off automatically after the program
start.
Manual switch on and off of the air nozzle. During
automatic operation, switching on and off takes place
automatically.
User's manual