Procedure During Operation; Using Unit Controls - Planmeca PlanMill 50 S User Manual

8.5 Procedure during operation

Referencing unit

8.6 Using unit controls

User's manual
NOTE
At every start the unit must be referenced using the control software. The
unit cannot be operated unless referencing has been performed.
Follow the steps below to reference the unit:
1. Turn the main switch located in the connection panel of the unit to ON.
2. Start the control software from the desktop.
3. Close the lid.
4. Press the POWER button.
5. Start the referencing of the unit when prompted by the control software.
The Planmeca PlanMill 50 S is equipped with a touch screen control panel
which is used for navigation and entering data.
The control buttons are located on the right side of the unit.
8 Operating milling unit
Planmeca PlanMill 50 S 45