Switching Between Wet And Dry Milling; Switching Off The Unit; After Operation - Planmeca PlanMill 50 S User Manual

8 Operating milling unit

8.18.3 Switching between wet and dry milling

8.19 Switching off the unit

8.20 After operation

62 Planmeca PlanMill 50 S
WARNING
The unit must be thoroughly cleaned before changing from wet to dry milling
and vice versa. Avoid any mixing of dry dust with the coolant. This dust/
coolant mixture can lead to severe contamination of the unit.
Use disposable towels to remove any residual coolant from the unit.
Do not use compressed air to remove milling dust from the unit. This may
cause fine dust to get into the mechanics of the unit and lead to the unit
being damaged or destroyed
Cleanliness and regular cleaning will increase the service life of the unit.
WARNING
The extraction unit provided by Planmeca is intended solely for the
extraction of DRY milling dust. Do not extract any coolant with the extractor
provided by Planmeca. This may lead to damage or even destruction of the
extraction unit.
1. Close the software on the control PC.
2. Shut down the PC as usual.
3. Turn the main switch located on the connector panel of the unit to OFF
position.
WARNING
Risk of injury by swarf! Swarf in the unit may have sharp edges and cause
deep lacerations.
NOTE
Protective clothing, safety shoes and gloves are required.
1. Switch the unit off as instructed in section "Switching off the unit" on
page 62.
2. Clean the unit (for detailed instructions, see section "Service,
maintenance and cleaning" on page 76).
User's manual